Customized candle tin manufacturers tell you that the tools/raw materials for making filling candles are Wax, double boiler, jars, labeled candle wicks, and pencils. Method/step: 1. Pick a wax. Customized candle tin manufacturers tell you that there are many kinds of wax online, paraffin wax, beeswax, and citronella. Of course, there are also some scented waxes. Pick what you need and buy enough.

2. Heat up the wax. Customized candle tin manufacturers tell you that use a double boiler to heat it to the point where it can be poured. The temperature needs to reach 82-88°C, which can be measured with a thermometer. You can also add a few drops of essential oil if you prefer.
3. Cut the wick. Customized candle tin manufacturers tell you to use a piece of wick that has been labeled (with a metal base) and glue it to the bottom of the jar. The wick needs to be long enough to reveal the head of the candle. Wrap a pen or pencil on top of the wick, and place the pen horizontally on the jar, making sure the wick is perpendicular to the bottom of the jar.
4. Heat the jar. Customized candle tin manufacturers tell you that in order to prevent bubbles when the wax is poured, the jar needs to be preheated. The jar can be placed in the microwave at 65.5°C and preheated for a few minutes.
5. Pour the wax. Customized candle tin manufacturers tell you that keeping the top wick still, slowly pour the melted wax into it. Avoid splashing on the sides or pouring too quickly so no air bubbles are created. Pour 3/4 this way and you're good to go.
6. Wait, keep pouring. Wait a few hours until the poured wax has set. At this point, there may be a groove in the upper part of the wax, continue pouring the remaining 1/4 into it. Finish. When the wax has solidified, you can remove the pencil and cut the wick to the right height to light the candle.
The above information is a customized candle tin manufacturer's introduction and analysis of the steps of hand-made canned candles, hope it helps you.